Product has attributes to select
IZOPLAST R’ is intended to prime concrete bases, cement and cement-gypsum coats, for the saturation of wooden elements (fencings, roofing shingles, etc.) and the creation of autonomous “light” insulation coatings.
HOW TO USE
Before priming and making “light” insulation coatings the base should be appropriately prepared i.e. to remove dirt and impurities, make the surface even, remove fossils, etc. If a new layer of screed is to be poured or gap-filling concrete poured, the priming must be performed after at least 10 days maturing,
- wooden, chipboard, and asbestos-cement surfaces: remove all mineral impurities, powder, dust, etc., fill in gaps/defects or replace rotten or decayed elements;
- steel structures, steel and galvanised sheets: remove rust, deposits of old paint, fats, greases, etc. Derusting is permissible to the 3rd cleanness class;
- priming and creating insulation coatings on metal surfaces: in each case, the cold product is applied to the prepared base with brushes, roofing brooms, or mechanically.
The time of coating skin formation – about 6 hours.
Priming – it is enough to apply the product evenly once on the whole surface.
The consumption of IZOPLAST R’ for priming and making the first insulation coating on metal surfaces is about 0.3 – 0.6 L/m2. For subsequent coatings on metal surfaces – about 0.2 – 0.4 L/m2.