Produkten har attribut att välja
|Förbrukning||19 kg/m²/1 cm|
|Appliceringstemperatur||From 5°C to +25°C|
|Kvantitet på en lastpall||42 pcs.|
Aggregate up to 4 mm
Excellent working parameters
It can be used on surfaces loaded with pedestrian and transport traffic
For non-structural concrete repairs as CC mortar
For making slopes on balconies and terraces
Frost resistant after hardening
For indoor and outdoor use
The surface must be hard, sound, rough, absorbable, not frozen, free from dirt and loose fragments, and free from dust. Moisten the surface with plenty of water without leaving stagnant water, so that it is matt wet. When using formwork, coat the formwork surface from the inside with a release agent. If required, arrange the reinforcement ensuring adequate insulation and protect it against corrosion. Free elements, i.e. posts, stabilize before concreting. All concrete works should be carried out in accordance with applicable rules.
Pour 25 kg (a bag) of dry webermix concrete B30 into 2.25 - 2.75L of clean water and mix with an electric mixer 2-3 min. to obtain a homogeneous consistency. When using low speed mixers or concrete mixers, the product should be mixed for 5-6 minutes. The addition of antispasmodic fibers is allowed. Prepare portions that will be used within approximately 1.5 hours. Do not add more water than the recommended amount, as this will reduce strength and increase shrinkage.
The ambient and surface temperature during work and for the next 5 days should be between + 5 ° C and + 25 ° C. The object must be protected against atmospheric precipitation. The surface should be protected against too rapid loss of moisture as a result of, e.g. high temperatures, drafts, solar radiation, etc. In order to ensure high quality, all work should be carried out using appropriate tools in an environment protected against dust, dust, polystyrene balls, etc., by contamination.