Produkten har attribut att välja
Pris från:
Katalog
Laddar...
SOLBET Cement Mortar for Thin Welds is designed for joining of cellular concrete blocks and boards, silicates and different types of building bricks. It may be used both for bricklaying and levelling of irregular surfaces.
The adhesive is suitable for binding plaster panels and plastering wall surfaces, smoothing plastered or even surfaces and absorptive concrete surfaces, as well as installing stucco on ceilings.
The adhesive is suitable for binding plaster panels and plastering wall surfaces, smoothing plastered or even surfaces and absorptive concrete surfaces, as well as installing stucco on ceilings.
Masonry mortar is designed for traditional masonry work such as walls made of bricks, hollow bricks and other similar ceramic, concrete or lime-sand materials. It is suitable for masonry work of above-ground storeys as well as cellar walls and foundations. It is suitable for indoor and outdoor use.
Silicate-polymer impregnate for concrete floors
weber.floor FLOW is a calcium sulphate-bonded, flowable screed mortar, which is used as base in floor heating systems, applied on thermal insulation, separating layer and binding with the groundwork.
weberfloor FIBROCEM is a special, high-performance and quick-setting binder intended for mixing with aggregate. Used for making cement screeds. It contains special admixtures, plasticizers and antispasmodic fibers.
Light-mortar masonry and plastering
Ytong adhesive mortar is special designed for Ytong blocks. It’s made of inorganic silicate cementitious materials and natural inorganic mineral aggregate, also together with polymer and water-retention factor. The homogeneous powder is made after sufficient mixing of each component. It is easy to use, just mix it with water. It has permanent adhesive property after sufficient maintenance.
